cancel
Showing results for 
Search instead for 
Did you mean: 
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
Diamondcare
New member
2 1 0 0
Message 1 of 4
268
Flag Post

Error with black head

HP Recommended
DJ510PS
Microsoft Windows 10 (64-bit)

Hi everyone one. I have problem with my DJ510PS. Its need to remove Block head and reinsert back to get print black color. Once i did so it will print one or two A1 size drawings. If i repeated the head change process then head alignment again ingetbone or two pages I tried two different new black head both same results. The black cartridge also tried new one. It like the ink system only prim while thw printer switch on time. We updated latest firmware. Is any issues with windows 10 drivers for this 510PS 24"?

 

Regards 

3 REPLIES 3
Repairatrooper
Level 13
Level 13
10,366 10,205 1,057 3,102
Message 2 of 4
Flag Post
HP Recommended

Need to make sure that the cartridge contacts are clean and properly spring loaded.

If you find the information provided useful or solves your problems, help other users find the solution easier by giving kudos and marking my post as an accepted solution.
I am a volunteer, offering my knowledge to support fellow users, I do not work for HP nor speak for HP.


Was this reply helpful? Yes No
Diamondcare
Author
New member
2 1 0 0
Message 3 of 4
Flag Post
HP Recommended

First thanks for your quick reply. You mean the ink cartridge contact or printer head contact. In the front panel menu the cartridge and head shows detected. I tested the ISS from service menu it pass the test. Is ther any option to prime printer head without setup cartridge? 

Regards 

Was this reply helpful? Yes No
chris1designjet
Level 4
63 63 4 10
Message 4 of 4
Flag Post
HP Recommended

Dear Dir

you have air in your inktube or using non original ink .

any how restart the printer 5 to 8 times with the ink cartridges inserted and the new printhead inserted  

and try to print  if it prints more then befor continues to print 

if  problem  comes back restart printer 3-4 times and use a needle ( simple injection ) after removing the printheads  remove the air in the ink tube  by using the sering gently insert it insted of the printhead  remove air   reinsert the printhead and perform alignment 

good luck 

 

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation