-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Printers
- DesignJet, Large Format Printers and Digital Press
- Only Light Cyan not printing on Light Cyan/Light Magenta Pri...

Create an account on the HP Community to personalize your profile and ask a question
09-13-2018 07:54 PM
We are having issues with the Light Cyan part of the Light Cyan/Light Magenta (LC/LM) print head going out shortly after installation. Its as if no ink is flowing through. There is no error messages. If I install another LC/LM printhead it also starts to go out only on the Light Cyan side. What could be the issue? Could it be that there is no pressure in the ink system?
09-13-2018 08:09 PM
Please check the LC/LM cap for ink tube which is connected with Printhead...maybe there have leack or not tight which is others like one.. ...That's why there haven't ink pressure in the ink tube for this color..... Please replace or any how change the plastic rubber and try... ..Otherwise you need to replace whole ink tube....
Before replace it, I you may perform ink leakage from diagnostic mode.
I hope that info. will help to you.
Regards
Rashed
https://www.linkedin.com/in/rasheddul
09-13-2018 09:58 PM
Yes I did that and even put a very thin amount of super glue to hold the cap and rubber in place. I put in a new print head and it is still banding like there is no ink going through. Could the print heads be defective from factory?
09-14-2018 02:34 AM
You need to use plastic glue for alternate. Otherwise need to replace the new cap or old good cap.
https://www.linkedin.com/in/rasheddul
09-30-2018 09:22 PM
Still not working. All caps was repaced with new caps. Tubes were bled. Contacts were wiped from printhead and on printer. Still the same issue after 8 brand new Light Cyan/Light Magenta print heads. Only Light Cyan is not firing. Light Magenta is still ok on all 8 brand new print heads. This new machine is down for more than 3 months.
10-01-2018 07:23 AM
Just manually clear the bubbles in the ink tube through 💉 injection shuck it.... And clean the Printhead with warm water on the nozzle....then try again. . . Please carefully check here no leakage in the ink tube.....ink supply station to Printheads cap. ..
https://www.linkedin.com/in/rasheddul