cancel
turn on suggested results
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Locked It has been a while since anyone has replied. Simply ask a new question if you would like to start the discussion again.
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
crmillerSJC
New member
1 0 0 0
Message 1 of 2
273
Flag Post

Plotter not finishing large job

‎04-06-2020 07:19 PM

HP Recommended
Product: T520 Designjet
Operating System: Microsoft Windows 10 (64-bit)

I am trying to print a 100" chart. The file is a pdf. The plotter will print the job the entire length but when it gets to the final 24" it only prints the lines and not the boxes that the lines connect to. I have tried multiple time and the ink is good. There are no issues printing other projects.There should be a lot of red boxes on the left side of org chart.There should be a lot of red boxes on the left side of org chart.

1 REPLY 1
Ouccema
Level 4
Level 4
116 116 9 15
Message 2 of 2
Flag Post

‎04-21-2020 01:59 PM

HP Recommended

Hi,

 

we suggest using the HPGL 2 driver: https://ftp.hp.com/pub/softlib/software13/printers/win-x64-hpgl2-drv.zip

and enable print as bitmap from printer settings in the driver. follow below path

Printer in control panel : -> printer preferences:-> advanced : -> Send job as bitmap

 

I am an HP Employee.
Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".

Didn't find what you were looking for? Ask the community

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation