Print quality DesignJet shortening or lenghtening print

[POSTER_COLOR]

Hello, I would like to solve the following problem that has been plaguing my DesignJet T2300 multifunction printer for a long time.

I would like to point out right away that sometimes it happens. You get several perfect prints and then, at certain times, this problem of overlapping or stretching of the print begins to appear.

I attach the photos to help you understand the problem. If it were a problem with the rotation of the paper feed or an effort in unrolling the paper roll, the problem would appear almost constantly, instead of appearing meters away or several times in a single meter.

I usually print in high quality and therefore in a unidirectional way, if it can be useful as data.

Do you have any suggestions on the matter?

[Raj_05]

Hey

Hope you are doing fine!

Thank you for visiting our English HP SupportCommunity. It would be ideal if the post was in English so that other HP product users like you can also benefit from the information provided here. To ensure a quick response, it would be advisable to post your question in English.

We understand that English is not your primary language, so we advise you to use an online translator of your choice to post in the language of our Community.

Thank you for your understanding.

Regards

[POSTER_COLOR]

Hello, I would like to solve the following problem that has been plaguing my DesignJet T2300 multifunction printer for a long time.

I would like to point out right away that sometimes it happens. You get several perfect prints and then, at certain times, this problem of overlapping or stretching of the print begins to appear.

I attach the photos to help you understand the problem. If it were a problem with the rotation of the paper feed or an effort in unrolling the paper roll, the problem would appear almost constantly, instead of appearing meters away or several times in a single meter.

I usually print in high quality and therefore in a unidirectional way, if it can be useful as data.

Do you have any suggestions on the matter?