cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
hriosm
Level 3
42 24 2 0
Message 1 of 2
176
Flag Post

Printheads not capped

HP Recommended

In my plotter, I have noticed the printheads are not being capped when in the parking position. I can see from the side (no right cover) that caps in service station move more to the front so the printheads are not covered/capped. I have tried the service station diagnostic and service station calibration but still not capping. What can I do? Please help me.

Regards

1 REPLY 1
Repairatrooper
Level 13
Level 13
8,554 8,453 888 2,593
Message 2 of 2
Flag Post
HP Recommended

Remove the right cover and examine the service station closely to make sure there is not foreign material blocking the movement. There is also a manual service station drive on the back of the service station that you use a t-10 torx to move the service station. You can try to manually cap the printhead to confirm the station works.

If you find the information provided useful or solves your problems, help other users find the solution easier by giving kudos and marking my post as an accepted solution.
I am a volunteer, offering my knowledge to support fellow users, I do not work for HP nor speak for HP.


Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation