Guidelines
We have new content about printers, Click here to check it out!
Get help with Large Format Printers, with direct access to all Large Format Knowledge Center· Ask anything · Find anything · Share anything at HP LKC
Locked

‎01-30-2022 08:42 PM - last edited on ‎03-17-2022 07:03 AM by Retired

HP Recommended

I am trying to print to 24' x 56" on a T210 plotter. Is it possible to print to this size on a roll? I am not having any luck.

Thanks

Category:
2 people had the same question
1 REPLY 1

‎01-30-2022 11:04 PM

HP Recommended

Hi,

Yes, the plotter supports up to 74.1 inches length.

 

You would need to create the paper size in the driver by selecting Create within the Paper Size list and specific your required paper size:

ShlomiL_0-1643609053257.png

 

 

I would also suggest trying to print your job within HP Click, to deny any possible conflict of your document by its editing software and see if that may work:

https://ftp.hp.com/pub/softlib/software13/hpdesignjetclick/HPClick-64bit-Setup.exe

 

Shlomi



Click the Yes button to reply that the response was helpful or to say thanks.
If my post resolve your problem please mark it as an Accepted Solution 🙂
Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.