cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
akas23
New member
3 2 0 0
Message 1 of 6
1,308
Flag Post

Solved!

T830 Cancels print shortly after printing

HP Recommended
HP T830
Microsoft Windows 10 (64-bit)

Our t830 cancels the print after 1 swipe into the print.

 

Load paper fine then cancels print. Goes on to say print is cancelled and that paper can not be removed and to do it manually.

 

Any thoughts?????

 

1 ACCEPTED SOLUTION

Accepted Solutions
Roy_Kuzmich
Level 6
217 187 21 32
Message 4 of 6
Flag Post
HP Recommended

 

Check the left side of the spindle. There is a cap that needs to be reseated. It has loosened out and will not allow the roll feed to work properly as it is binding the rewinder.

 

Good Luck,

 

Roy K

View solution in original post

Was this reply helpful? Yes No
5 REPLIES 5
akas23
Author
New member
3 2 0 0
Message 2 of 6
Flag Post
HP Recommended

On further inspection, we believe it might be a roll feed problem. 

 

The roll doesn't seem to be rolling back after loading and the paper is very loose. 

 

If you roll it back manually it works on occasions.

Was this reply helpful? Yes No
computeck
Level 2
27 26 0 2
Message 3 of 6
Flag Post
HP Recommended

It seems to be a sensor paper problem due to it is not working properly. try to calibrate paper sensor and try again to print.

1. get into menu

2.- get into service calibrations

3.- get into paper sensor calibration

4.-follw on panel instructios

5.- resend job

Some times a hardware problem cancel a job, in that situation, check if some of the printheads or cartdriges is having a problem and replace it.

Good luck

marco from computeck

Was this reply helpful? Yes No
Roy_Kuzmich
Level 6
217 187 21 32
Message 4 of 6
Flag Post
HP Recommended

 

Check the left side of the spindle. There is a cap that needs to be reseated. It has loosened out and will not allow the roll feed to work properly as it is binding the rewinder.

 

Good Luck,

 

Roy K

View solution in original post

Was this reply helpful? Yes No
akas23
Author
New member
3 2 0 0
Message 5 of 6
Flag Post
HP Recommended

This is exactly what was wrong!!!!

 

Lucky we found this out eventually - Being in regional Australia it is a costly exercise to get a technician out - would've felt awful if it was discovered that it was only the cap on the spindle.

 

 

Was this reply helpful? Yes No
Roy_Kuzmich
Level 6
217 187 21 32
Message 6 of 6
Flag Post
HP Recommended

Glad I could help you out.

Please dont forget to mark the issue as solved so others can see.

 

Roy K

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation