• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
Get help with Large Format Printers, with direct access to all Large Format Knowledge Center· Ask anything · Find anything · Share anything at HP LKC
Locked

‎12-06-2021 05:37 AM

HP Recommended
Product: Designjet 111
Operating System: Microsoft Windows 7 (64-bit)

Hi,

I use the HP Designjet 111.
After intensive nozzle cleaning, the plotter continuously prints test prints every time it is switched on. I also replaced the magenta printhead. How can I turn this off ?

Category:
1 REPLY 1

‎12-06-2021 07:24 AM

HP Recommended

No, you can only cancel it every time it starts to align by pressing X button a few times.

The automatic calibration must be completed when printhead(s) is replaced and the printer will continue to start calibration every time it's turned ON until fully completed.

 

https://www.youtube.com/watch?v=IisFEhAgeu8 




My profile on LinkedIn

Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.

Didn't find what you were looking for? Ask the community

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.