cancel
Showing results for 
Search instead for 
Did you mean: 
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
Killewipp
New member
1 0 0 0
Message 1 of 2
196
Flag Post

Testprints every Time

HP Recommended
Designjet 111
Microsoft Windows 7 (64-bit)

Hi,

I use the HP Designjet 111.
After intensive nozzle cleaning, the plotter continuously prints test prints every time it is switched on. I also replaced the magenta printhead. How can I turn this off ?

1 REPLY 1
Valsimot
Level 12
Level 12
6,901 6,122 812 1,139
Message 2 of 2
Flag Post
HP Recommended

No, you can only cancel it every time it starts to align by pressing X button a few times.

The automatic calibration must be completed when printhead(s) is replaced and the printer will continue to start calibration every time it's turned ON until fully completed.

 

https://www.youtube.com/watch?v=IisFEhAgeu8 




My profile on LinkedIn

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation