• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
We have new content about printers, Click here to check it out!
Get help with Large Format Printers, with direct access to all Large Format Knowledge Center· Ask anything · Find anything · Share anything at HP LKC
Locked

‎02-24-2018 11:23 AM

HP Recommended
Product: Z2100 DesignJet
Operating System: Microsoft Windows 10 (64-bit)

I have a large format plotter Z2100 Designjet. I continually get the same error 86:01 as the system boots up and I load paper.  Carriage always stos in the sam location - a few inched out of the service station.  I have done all the online suggestions: oiling cleaning ect.  The carriage moves freely befor and after the error.  

When I do the Scan Axis Diagnostics I get a speed error stating the max speed of 46 has been exceed (it is at 51.2).  Im not sure if the problems are related but its the only thin I got through the diagnostic process. Is there a way to lower the speed to come into spec? Any help would be much appreciated.

1 ACCEPTED SOLUTION

Accepted Solutions

‎03-11-2018 09:47 PM

HP Recommended

After trying all of the usual suggested fixes,  I tried a new Scan Axis Motor and it worked great.  Not a 86:01 error after that.

View solution in original post

Was this reply helpful? Yes No
2 REPLIES 2

‎03-10-2018 04:41 PM

HP Recommended

Hello,

 

Did you try to clean the encoder strip?

 

https://support.hp.com/gb-en/drivers/selfservice/hp-designjet-sd-pro-scanner/7420666/model/7420667

 

As per your description the issue is only when loading paper rigth? 

 

it is the same issue if you load a sheet of paper?

 

BR

Juan

I am an HP employee
Was this reply helpful? Yes No

‎03-11-2018 09:47 PM

HP Recommended

After trying all of the usual suggested fixes,  I tried a new Scan Axis Motor and it worked great.  Not a 86:01 error after that.

Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.