• ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Windows update impacting certain printer icons and names. Microsoft is working on a solution.
    Click here to learn more
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
We have new content about cartridges, Click here to check it out!
Get help with Large Format Printers, with direct access to all Large Format Knowledge Center· Ask anything · Find anything · Share anything at HP LKC
HP Recommended
HP DesignJet L26500
Microsoft Windows 7 (64-bit)

hello ..please i need help ...my HP DesignJet L26500 got this errorcode..how to solve?

 

 

14.08:00

No power in heating modules

Check cables and switches.

If necessary, call support.

 

Coution! hot surfaces

inside the printer. Do not

touch heating modules.

3 REPLIES 3
HP Recommended

Tech support is required..

Check this out:

14.08:00

Description

No AC voltage in the Dryer Assembly. The firmware has detected that there is no AC voltage in the Dryer Input connection.

Remedy

• Check that the power cables are correctly inserted at the rear of the printer. Check to see if a fuse has blown on one of the electrical input cables (when the region has a fuse in the power cord). • Check to see if the Residual Current Circuit Breaker (RCCD) has blown, reset it, if it blows again immediately (or often), this would indicate an error with the Dryer Assembly or the RCCD. • Check the electrical supply from the customer´s site. • Check that the power cables are correctly inserted at the rear of the printer. • Check to see if the Residual Current Circuit Breaker (RCCD) has blown, reset it, if it blows again immediately (or often), this would indicate an error with the Dryer Assembly or the RCCD. • Check the connections of the cables from the Dryer input connection, RCCD, the filter and the Heater Control Assembly. • Check to see if the fuses F1 and F2 have blown on the Heaters Control Assembly , if they have replace the Heater Control Assembly . • Check the 24 Volt LED on the PrintMech is on, see , check the connections between the Heaters Control assembly and the PrintMech PCA, try disconnecting and reconnecting them. • One of the following PCAs has failed and must be replaced: • Replace the Heater Control Assembly . • Replace the PrintMech . • Replace the Sausalito PCI PCA .

HP Recommended

Hai Skuks, thansk for your help, but still could not help me... 😞

HP Recommended

Like I wrote - call the hp tech support. Only you can do is check the mains for delivering righ voltage and cable to the printer is not faulty... Upgrade firmware if not done yet..printer must be opened and checked for all described in previous answer..

https://www.google.com/url?sa=t&source=web&rct=j&url=https://shared.swissparts.ch/Manuals/HP/Plotter...

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.