Create an account on the HP Community to personalize your profile and ask a question
12-27-2018 08:19 AM
I seen this error on my last repair Z3100 44" & when carriage box moved to the left & shaked little & that error
At the end I replaced the scan axis motor & no error & loaded paper to perform printhead alignment.
If you have one lay around & try to swap it. Easy, just release the tension of belt & few screws..
No garrantee, for reference only...
12-27-2018 08:35 AM
before you buy a new motor, check & try tension of the belt, lubricate the silver metal rod .
Myself did not believe it, because prior repair & the printer had no that error message. I spent over a week & got
no solution & at then end I made the decision.
My post should be still on this board.
Didn't find what you were looking for? Ask the community