cancel
Showing results for 
Search instead for 
Did you mean: 
HardikP
New member
3 2 0 0
Message 1 of 6
2,603
Flag Post

2223-EIT failure. VT must be enabled to launch VA.

HP Recommended
hp compaq dc7800 small form factor
Microsoft Windows 7 (32-bit)

2223-EIT failure. VT must be enabled to launch VA.

5 REPLIES 5
Grzwacz
Level 12
Level 12
6,774 6,758 637 1,524
Message 2 of 6
Flag Post
HP Recommended

Greetings,

Welcome to the forum.

I am not a HP employee.

 

Did you enable virtualization in the BIOS?

 

Regards

0 Kudos
HardikP
Author
New member
3 2 0 0
Message 3 of 6
Flag Post
HP Recommended

Yes, after enabling, saving bios, boot up shows horizontle bli kung cursor only, then no any progress.

0 Kudos
Grzwacz
Level 12
Level 12
6,774 6,758 637 1,524
Message 4 of 6
Flag Post
HP Recommended

Hi,

 

Sorry, not following your last response ( boot up shows horizontle bli kung cursor only, then no any progress).

 

Don't know what the above statement in parenthesis means.

 

Regards

0 Kudos
HardikP
Author
New member
3 2 0 0
Message 5 of 6
Flag Post
HP Recommended

Enabling VT settings in bios, system shows only blinking cursor after that no progress on screen.

0 Kudos
Grzwacz
Level 12
Level 12
6,774 6,758 637 1,524
Message 6 of 6
Flag Post
HP Recommended

Hi,

 

So you enable virtualization in the BIOS and save and exit but you can't start Windows.

 

I have no idea why this is happening.

 

Have never seen this behavior before.

 

Regards

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation