cancel
Showing results for 
Search instead for 
Did you mean: 
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
Kemet357
New member
1 0 0 0
Message 1 of 2
264
Flag Post

HP ENVY All-in-One / Doesn't boot/start up normally, 6 beeps and nothing

HP Recommended
HP ENVY Recline 27-k150xt TouchSmart All-in-One
Microsoft Windows 10 (64-bit)

So my PC doesn't boot or start up as it sould just started yesterday. I have been Googling and Youtubing for hour's. The back light; light up then is gose black.  Then the same thing happens and then you hear 6 beeps with the same tone and length then nothing.

  • Unplugged and plugged it back in
  • Held the power button down for 15 to 60 sec. with it unplugged
  • Removed the ram and re-installed the ram

So then I removed the Cmos Battery for about 15 to 20mins "anything less didn't work" plugged everything backup and the some thing happens 6 beeps etc...

 

Then I repeated  the Unplugged hold for 15sec. and plugged everything backup; THEN I get the HP logo and it starts up.  But after you do a rest the 6 beeps of death are back.

 

So I did these steps with no luck!

  • Once it started, I let the PC try to repair and fix the issue 
  • Accessed the Bio
  • Checked the boot sequence order
  • Reconfigured the boot sequence order
  • Ran a diagnostic on the Ram & Hard drive both PASSED
  • Rest to default 
  • Checked the boot sequence order
  • Reconfigured the boot sequence order
  • Ran a diagnostic via the Bio on the Ram & Hard drive both PASSED
  • Went into Device Manager updated everything that could be update including the obvious stuff related to this issue

I want to flash the Bio's in hopes that will work but HP doesn't offer any downloads available for this Years: 2014, Make: HP and Model: 27-k150xt and the only other thing I can think of is moving the jumper around on the mother board. Other then that I'm lost. Please help

1 REPLY 1
Grzwacz
Level 12
Level 12
7,153 5,604 681 1,651
Message 2 of 2
Flag Post
HP Recommended

Greetings,

Welcome to the forum.

I am not a HP employee.

 

A six beep BIOS error code for PCs made before 2015 indicates a problem with graphics (Link).

 

You may have to replace the system board because your PC has integrated graphics.

 

Regards

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation