• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Are you having HotKey issues? Click here for tips and tricks.
Locked

‎07-06-2022 02:47 PM

HP Recommended
Operating System: Microsoft Windows 10 (64-bit)

I have a Elitedesk 705 G4 MT that came with 1 8GB memory module installed. It has 4 DIMM slots and supports up to 64GB installed. I purchased a DDR4-2666 32gb kit (2x16GB) and installed the new memory (removing the old 8GB) and it will not boot. It powers on, the fans spin and the nic flashes but nothing else. No beeps, no error, no anything.

 

If I install just the 8GB module or either of the 16GB individually it boots normally. Both 16GB modules pass the memory diagnostic individually, but I can't get the system to boot with 2 memory modules installed in any slot combination.

 

I'm about to toss this whole thing, hopefully someone here has some idea.

Category:
1 person had the same question
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.