cancel
Showing results for 
Search instead for 
Did you mean: 
Jmeredith
New member
1 0 0 0
Message 1 of 2
201
Flag Post

No signal on monitor after power outage

HP Recommended
Microsoft Windows 10 (32-bit)

I have a “no signal check cable or video source” error after a power outage. It was plugged into a surge protector.

 

i verified that monitor and hdmi are good by plugging in another source and got video. 

 

monitor status

vga: inactive

hdmi: inactive

 

 

1 REPLY 1
Grzwacz
Level 12
Level 12
6,774 6,758 638 1,525
Message 2 of 2
Flag Post
HP Recommended

Hi,

 

You verified the monitor and HDMI cable work.

 

So this suggests the power outage or restoration of AC power may have damaged the PC.

 

Surge protectors have limitations.

 

What is happening when you start the PC? Any startup sounds or active LEDs on the front and back of the chassis?

 

Regards

 

 

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation