cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
New member
1 0 0 0
Message 1 of 2
308
Flag Post
HP Recommended

Unable to boot - Hard Disk Error (3F4) on a drive that doesn't exist

HP Envy 570
Microsoft Windows 10 (64-bit)

I'm unable to get my desktop to boot up properly about 90% of the time. It just sits on the black screen with the HP logo and the spinning dots forever.

 

During bootup, I see the following error

WP_20190115_14_18_23_Pro.jpg

 

The strange thing is I only have two drives on my machine - one SSD and one HDD. My SSD has Windows and all of my applications, while my HDD has data files for an x64 program I'm currently developing. These should be drives 0 and 1 ( or 1 and 2 not sure if the error codes are 0 based ). So I have no idea what Hard Disk 4 is referring to.

 

I've run every diagnostic test available from the boot menu and everything passes without issue. However once I exit the boot menu it stays hung on the HP loading screen as described above. Every once in a while it will boot up properly, and I have zero issues ( no data loss, no hangs, no disk detection issues ) returning from sleep mode, but whenever I have to restart or cold boot I get right back into this loop of being unable to boot without trying 100 times.

 

Any help here would be greatly appreciated. Since there is no Hard Drive 4 I have no idea where to look. I thought maybe it was a motherboard issue or something but it seems strange that there are no other issues whatsoever with the machine, and I would expect to have many more issues if my motherboard were failing.

1 REPLY 1
Highlighted
Level 12
Level 12
6,006 5,992 565 1,264
Message 2 of 2
280
Flag Post
HP Recommended

Unable to boot - Hard Disk Error (3F4) on a drive that doesn't exist

Greetings,

Welcome to the forum.

I am not a HP employee.

 

I can't look at your PC's specs using Envy 570. You should have, per your post, two storage devices and a optical drive.

 

Check SATA data connections on the motherboard to isolate disk 4. HP starts drive delineation at port "0". Maybe you have a drive connected to SATA port 4?? Try a different lower numbered SATA port.

 

You have an intermittent problem; very hard to troubleshoot. I would try new SATA data cables for SATA devices connected to the motherboard.

 

You stated HP Diagnostics pass. Are you testing all storage devices?

 

Try running Microsoft's System File Checker (Link) on both storage devices when running Windows.

 

Intermittent problems are very hard to troubleshoot.

 

Regards

0 Kudos
Be alert for scammers posting fake support phone numbers on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation