USB issue

[SOCPA]

Dear Support Team
Happy day
In our facility, we use PC type (HP EliteOne 800 G3 23.8-inch Touch All-in-One PC 2SG35EA )
Problem When the printer is connected, an error message appears below

'' Unknown USB Device (Device Descriptor Request Failed ''

Sometimes the printer works for a while and then the message appears
All methods have been used to solve the problem and we still suffer from it

We hope you will support us in solving this problem

Best regards 

[savvy2]

1: try other  USB ports , usb2 and 3,  if it has usb3 ports use usb 2.

2: try new USB cable.

3: reload the printer software from HP?

4: make sure USB port driver is present, and used, is ok in device manager,  on my elitebook usb ports are dead, usb 3.

they are dead because not supported by HP for w10, so found them at NEC for USB3 chip and fixed my elitebook that way.

5; SCAN THE PC FOR MALWARE?

6: TASK MANAGER LOOKING OK? no CPU overloaded,  at 99%

7: do a hard reset on the printer yet, and then reforce it back to USB  mode? (if printer ;has 2 modes wifi/usb, reset it)

8 read   your w10 event logs?

hoping for you, that my ALL solutions are more...