Displayport connection isn't working with new OMEN X 27

RobNAC · ‎11-09-2023

Hello, not sure if i'm in the correct board but i'm having troubles with my new Monitor. I've recently built a PC and changed monitors along with it. My first money works perfectly and is connected via display port (different brand) but this Omen x 27 will not work. They are both connect to the motherboard display ports and the GPU is brand new (7900 XTX). The Omen x 27 will work with a HDMI connection but the display port won't. I've troubleshooted by using a different monitor and swapping ports etc and it all works apart from when using the Omen x 27. It just tells me (Input signal not found, Check the video cable etc). Any ideas on how to fix this? I've tried drivers and everything but nothing works.

banhien · ‎11-09-2023

@RobNAC

How do you connect them ?

Regards

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.

RobNAC · ‎11-09-2023

I connect them both with display port cables into the graphics card display port slots

TheOldMan · ‎11-10-2023

Here is the User guide http://h10032.www1.hp.com/ctg/Manual/c06427949.pdf

Page 14 describes how to use the Display Mode and switch between inputs.

You might also need to right click on a blank part of the desktop and then pick "Display Settings" and the pick "multiple displays" and following to get Windows setup properly for two displays.

I'm not an HP employee.
Did this message answer your question? Please indicate below as an Accepted Solution!
Did you find this message useful? Click on the "Was this reply helpful" Yes button.

Create an account on the HP Community to personalize your profile and ask a question