-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Desktops
- Desktop Video, Display and Touch
- No video on boot HP ENVY 700-216

Create an account on the HP Community to personalize your profile and ask a question
08-28-2022 01:40 PM
When I boot up, I get no video “No signal”. With no video, I can’t get into the bios to disable the onboard video so I can add a video card in the open PCIe slot. I did install the the card NVIDI GEFORCE GT 730 but still no video. When the pc boots I don’t get any beeps either. Any ideas?
I have reseated the memory and still no help.
thanks
08-29-2022 06:15 AM
Assuming this setup has worked in the past, and the “No signal” just started to show, what else might have changed?
Unless the connecting cable has been disconnected or broken, it could be the monitor input has failed. Since the monitor is the same, try a different input. Most monitors have the capability to accept a different type of input.
According to the spec page your PC has VGA and DVI-D outputs. Whichever is being used now, try the other one. Of course a different cable will be needed.
I'm not an HP employee.
Did this message answer your question? Please indicate below as an Accepted Solution!
Did you find this message useful? Click on the "Was this reply helpful" Yes button.
08-29-2022 09:50 AM - edited 08-29-2022 09:51 AM
If using DVI output does not help, you can install that NVIDI GEFORCE GT 730 again and remember that you then need to move the monitor cable to the NVIDI GEFORCE GT 730 outputs.
I'm not an HP employee.
Did this message answer your question? Please indicate below as an Accepted Solution!
Did you find this message useful? Click on the "Was this reply helpful" Yes button.