• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
The HP Community is where owners of HP products, like you, volunteer to help each other find solutions.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.

‎05-03-2017 11:08 PM

HP Recommended
Product: HP Pavilion p6-2357in Desktop
Operating System: Microsoft Windows 10 (64-bit)

How to reset BIOS password in this model cupertino3 motherboard(HP Pavilion p6-2357in) ?

what i have did on this question - I have remove power cable, then remove jumpers in motherboard(CMOS and password jumpers) and other jumper(ROM recovery header). then replace them diffrent pins then power on CPU BIOS password doesn't cleared how to fix it?

and when goes to booting mode it's occur the following message error: no boot disk has been detected or the disk has failed. so i cann't boot to hard drive but i have check hard disk to other Desktop cpu it's working fine what is the issue in motherboard?

 

Any one can reply me..

 

2 REPLIES 2

‎05-03-2017 11:36 PM - edited ‎05-04-2017 12:46 AM

HP Recommended

 

Did you follow the directions at bottom of page? Although the printed directions seems to conflict with the photo of jumper pin. I would follow photo. Wait 10 seconds before replacing to default pins.

https://support.hp.com/us-en/product/hp-pavilion-p6-2300-desktop-pc-series/5295969/model/5300251/doc...

**Click Accept as Solution on a Reply that solves your issue**
***Click the "YES" button if you think this response was helpful.***

‎05-04-2017 07:34 AM

HP Recommended

Hi, @Manikandank :

 

The written instructions for clearing the BIOS password are incorrect on a few HP consumer desktop model series.

 

I reported this matter to HP last year and I guess they missed correcting this one.

 

I have modified the instructions below...

 

To erase the BIOS password follow these steps:
 
  1. Turn OFF and unplug the computer.
  2. Move the jumper pins from 2-4 (default) to pins 4-6.
  3. Plug in and power on the computer.  The BIOS password should now be cleared.
  4. Turn OFF and unplug the computer.
  5. Then move the jumper back to its default position (2-4).
  6. Plug in and turn ON the computer.
Archived This topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.