Create an account on the HP Community to personalize your profile and ask a question
12-12-2020 04:22 PM
Product: Hp Pavilion 16-a0032dx
Operating System: Microsoft Windows 10 (64-bit)
Hello everybody, I just bought an HP laptop with 500GB SSD and 32GB optane. Yesterday, I just wanted to replace the optane with the new M.2 SSD 500GB, and I have followed the instruction to disable optane in Intel Optane Storage and Management. However, after disabled and removed this card, and replaced with the Crucial NMVE M.2 SSD, I cannot boot my laptop, and it keeps always " Bootable Device Not Found."
I have tried to re-install back the Optane, and it can start again but the error always happens when I removed the Optane and replace it with the new M.2 SSD card. I have no ideas on what I did wrong please help me!!!
1 REPLY 1
12-12-2020 08:28 PM - edited 12-12-2020 08:28 PM
@Kanbo8695 , welcome to the forum.
If you are using the new M.2 as the boot drive, did you go into the BIOS/UEFI and set it as the boot drive? Also, did you clone the original SSD to the new SSD or do a clean install of Windows?
I am not an HP Employee!!
Intelligence is God given. Wisdom is the sum of our mistakes!!
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
Didn't find what you were looking for? Ask the community