Post new question
Question
Reply
 
Highlighted
Student
Posts: 1
Member Since: ‎05-17-2017
Message 1 of 2 (347 Views)

Cannot log into new install of Web JetAdmin

Product Name: Web JetAdmin
Operating System: Microsoft Windows 10 (64-bit)

Hey All, I need some help!

 

I did a fresh install of HP WebJetAdmin on Server 2012 R2.  After the install, I am able to access the console, but I can't log in.

 

I don't recall it ever asking to create a username and password, and I cannot find anywhere in the documentation what the default username and password is, so I can't log in to it!

 

Any ideas?

Reply
0 Kudos
Intern
Posts: 19
Member Since: ‎01-07-2015
Message 2 of 2 (188 Views)

Re: Cannot log into new install of Web JetAdmin

By default WJA will not prompt for any credentials to log on to WJA GUI.

The ƭrst time you launch HP Web Jetadmin after installation, a pop-up dialog is displayed stating that no devices
have been discovered. You can opt to launch discovery settings at this point.

 

You can log in to your Server 2012 R2 and open HP WJA application.

Here is an example of the URL used to activate HP Web Jetadmin on a supported Windows desktop: http://myhost:8000

 

Then you should be good to go.

 

Say thanks by clicking the Kudos Thumbs Up in the post.
If my post resolved your problem, please mark it as an Accepted Solution

I am an HP employee
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation