50.2F.00

[ZZZAJ]

The printer is getting this Error Code 50.2F.00 I replaced the fuser same Error. Plus it makes this noise as well. Can someone give me some help on this. Zack

[Alex-TATS]

Hi @ZZZAJ,

This is a fuser warm up failure.

1.       Turn the product off. Remove the fuser, and then reinstall it.

2.       Remove Fuser and check fuser connection to printer, If it is damaged, Replace the fuser assembly (read before replacement) .

3.       If connector on printer is damaged replace Fuser Wire harness

4.       If the error persists, replace the fuser assembly (read before replacement) .

5.       If the above does not resolve the issue, Replace the LVPS or/and DC Controller

Regarding the noise, try doing a component test and actually try verifying that it comes from the fuser motor test. If this is the case remove the fuser drive assembly, inspect it for any damage and replace it if need so.

I hope this helps,

Cheers!

[elmountassif]

you should to change your printer fuser

[sinasteria]

as per alex's statement

[Arthur-c]

Hello,

Thank you for posting in this thread. Unfortunately based on when the last response was made, I have closed this thread to help keep comments current and up to date. We recommend starting a new thread for your issue by clicking here.
To be more helpful with your post, you can add key information if you desire: 
1. Product Name and Number (please do not post Serial Number)
• Example: HP Pavilion DV2-1209AX or HP Deskjet 3000 Printer CH393A
2. Operating System installed (if applicable)
• Example: Windows XP, Windows Vista 32-bit, Windows 7 64-bit
3. Error message (if any)
• Example: ""Low disk space"" error in Windows
4. Any changes made to your system before the issue occurred
• Examples: Upgrading your Operating System or installing a new software; or installing new hardware like a printer, modem, or router.
If you have any other questions about posting in the community, please feel free to send me a private message!

Thank you