cancel
Showing results for 
Search instead for 
Did you mean: 
JohnW11
New member
2 0 0 0
Message 1 of 4
164
Flag Post
HP Recommended

Firmware update stops Laser Jet Pro M102w

Laser Jet Pro M102w

After doing a firmware update on Laser Jet Pro M102w today all I get is a blinking green button.  When I looked to add it to my computer it now says it is a HP Laser Jet 3020 but will not print to it.  I have seen in the forums that a possible solution is a factory reset but I don't know how to do that.

 

I have tried unplugging for awhile and have also tried to update again.  The former did nothing and the later did not work because the printer is no longer seen by the software.

 

Help.

3 REPLIES 3
HP Support Agent
HP Support Agent
18,344 18,252 1,046 1,150
Message 2 of 4
120
Flag Post
HP Recommended

Firmware update stops Laser Jet Pro M102w

@JohnW11

 

Welcome to HP support community.

 

I am sending you a private message with the steps to perform NVRAM reset on the printer, which are particular for your printer model. Please check the mailbox icon at the top-right corner of this screen.

I hope this helps resolve this issue completely.

 

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others

Cheer.

Sandytechy20
I am an HP Employee

Reply
0 Kudos
RedDelicious
New member
4 4 0 0
Message 3 of 4
83
Flag Post
HP Recommended

Firmware update stops Laser Jet Pro M102w

Same happened to me! Please send the NVRAM reset instructions.

 

Thank you!

Reply
0 Kudos
HP Support Agent
HP Support Agent
9,824 9,827 866 1,037
Message 4 of 4
57
Flag Post
HP Recommended

Firmware update stops Laser Jet Pro M102w

@RedDelicious

 

Please check your private message 🙂

 

Thanks! 

Asmita
I am an HP Employee

Reply
0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation