How do I change the IP Address of HP LaserJet P2035n Printer

[LUGUY]

My Priner have it's original IP Addres since I installed it the firs time, the problem is it was in a work network, but now is on a home network, I need to change the IP because I have a new printer on the previous place using the original IP Address; My question is: How I can change the IP Address? Some HELP? Thank you

[Bonzer5]

Easiest way to change this is from the embedded web server on the printer. If you know the old IP address you should be able to connect to it by typing the IP in a web browser (you might need to connect your computer directly to the printer via ethernet if your network doesn't know the route to the printer IP). If you don't know the IP, then press and hold the "Go" button down for 5 seconds and a config page should print showing the current IP.

[LUGUY]

Thank you Bonzer5. Yes I know the Printer's old IP Address, actually the printer is working fine, the problem is that in the place where inicially I installed this printer I have another printer & now I have two printers with the same IP, one on Work Network & the other on Home Network & in different locations, & windows is telling me I have 2 devices with the same IP. I need "Step by Step" on how to change the IP address using the embedded web server.

Thank you

[Bonzer5]

The User Guide on page 26 here only says to type the IP address into the addresss line of a Web browser and to click the Networking tab to see and change information as needed. I don't have one, so I can't screenshot, but usually these settings are pretty straightforward.

[davidzuts]

Try the procedure below and see if the network settings change. After the reset run the config page by pressing the go button for 5 seconds when the printer is ready and release when you lights start to blink.

● For HP LaserJet P2030 Series Printers, restore defaults by pressing and holding the Go button
and Cancel button for 10 seconds while turning on the product.

[LUGUY]

Thank you. Now the trouble is bigger, In EWS when click on "Settings" it asking me for User Name & Password, witch I didn't configure this before, any help in this matter?