LaserJet Pro CM1415 FN shows error "Paper Jam in Tray 1" every time I try to print more than 1 pages

[OveU]

LaserJet Pro CM1415 FN shows error "Paper Jam in Tray 1" every time I try to print more than 1 pages. When I press OK without trying any fix it continues printing and then the same error occurs for each page.

[east2100]

It's the problem of pick-up roller.

When printing the pickup roller should grab paper to reach a certain aera and touch a sensor then the printer will get into next processing and finish the print job.

What your problem is that the paper didn't get to the certain aera so it jamed.

You can try to clean the pickup roller first to see if it helps if it's not then it should be replaced.

Another way to prevent is to slow down the speed of printing by changing the default paper type from plain to heavy paper or card.

What i post below which copyed from someone else not coming from myself.

Hope it helps.

Use below settings in resolving this frequent cleaning mode, misprint issues:
These settings need to be changed only in printer using ToolboxFX or EWS.
* Do not change/modify any settings in printer drivers. Leave the printer drivers with default settings.

In System Tab and Paper Handling:
Default Paper Size: Letter
Default Paper Type: Plain
Manual Feed: Off
Tray 1 Size: Any Size
Tray 1 Type: Any Type
Tray 2 Size: Letter
Tray 2 Type: Heavy 111-130g
Tray 3 Size: Letter
Tray 3 Type: Heavy 111-130g

In Paper Out Handling:
Select Specify Time and Action.
Paper Out Time: 0 Seconds
Paper Out Action: Override

In System Tab and Print Quality:
Power-On Calibration: 60 Minutes
Calibration Timing: 168 hours