-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Printers
- LaserJet Printing
- LaserJet Pro M1212nf MFP - Initialization loop does not come...

Create an account on the HP Community to personalize your profile and ask a question
03-02-2020 04:45 AM
LaserJet Pro M1212nf MFP - is switched on enters Initialization loop and does not come to Ready/OK Status.
Hard factory reset attempted with no luck. Printer remains in same loop. Currently Printer is not connected to computer or network.
Any ideas?
03-02-2020 05:18 AM - edited 03-02-2020 05:20 AM
Hello,
I have sent you a private message with instructions to reset (Permanent storage init.) the printer. Please only change the fields quoted in my private message.
I ask you not to republish the procedure indicated in my PM in the public community and I thank you for doing so.
Then, please update the printer's firmware using the USB connection from the following HP link:
https://ftp.hp.com/pub/softlib/software13/COL32625/bi-122315-3/LJM1130_M1210_FW_Upgrade_Security_sig...
If this answer allows you to solve the problem, please close the subject by clicking on Accept as solution at the bottom of this message.
Afterwards I invite you to come back here.
I remain at your disposal in case of need.
Best regards,
03-02-2020 12:09 PM
Have you tried the following solution?
Try the following solution:
- Turn off the printer.
- Press and hold the Right Arrow and Cancel buttons.
- While holding these buttons turn on the printer. The printer returns to Ready status.
Do not hesitate to contact us in case of need.
Best regards,