Laserjet Pro m130fn password

[NikolayPopov]

Hi guys, I have the following problem with m130fn. It was working as network printer until it changes its IP address and set password to its settings. Now I can't go to settings because it requires password. Could you tell me a key combination or other way to restore it to factory defaults. Thank you! 

[Vidya]

@NikolayPopov

Try using the username as "admin" and the password as "admin" (without quotes) and check if you are able to access the printer's EWS page. 

If the issue persists, reset the printer to its factory defaults. Refer to page number 131 in the user manual. 

Click here for the user manual. 

Page number 115 will help you configure a password to the printer settings. 

You would need to reconfigure the printer and on all the computers and devices you would need to reconfigure the printer. 

[TheCurmudgeon]

Hi NikolayPopov,

To restore the factory defaults:

1. On the printer control panel, press the Setup button (the wrench icon) to open the Setup menu.
2. Use the left or right arrow buttons to find the Service menu, and then press the OK button.
3. Select Restore Defaults, and follow the onscreen prompts. The printer automatically restarts.

All of the printer and network settings will be reset. It will also delete any pages currently stored in the printer memory.

I hope this helps in resolving your issue!

[NikolayPopov]

When I try to enter the settings I can't because it requires password. That's why I ask you for key combination or other way.

[Vidya]

it may need step by step guidance...[personal information removed]