Low memory on HP Laserjet Pro 200 color MFP M276 nw

[Pecish]

My printer started to show memory low warnings and failed to print some graphic-intensive pages today. Diagnostic printout shows only 127.83 / 256 MB memory available. I have carried out a firmware update, hard power reset and NVRAM reset as per instructions found on this forum but the memory issue persists. Please can anyone advise me on how to fix this issue?

[Andr-1611]

Hello @Pecish,
Welcome to the HP Support Community!

You try this:

Preferred method: Clear Saved Faxes (Go to
Setup ---> Service ---> Fax
Service ---> Clear Saved Faxes

Hope this helps! Keep me posted.
Andreas

If my post resolved your problem please mark this post as an "Accepted Solution".
Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks”!

[Pecish]

Hi, Andreas

Thanks very much for your suggestion. I've cleared saved faxes as instructed and printed the diagnostic report again afterwards. Unfortunately it still shows 127.83 MB available out of 256 MB total. Maybe this is normal?

Paul

[Andr-1611 · Accepted solution]

Hi Paul,

---

@Pecish wrote:
.. My printer started to show memory low warnings and failed to print some graphic-intensive pages today.

---

Is this message still displayed?

Regards
Andreas

[Pecish]

Hi, Andreas

I've just tried printing out the same graphics again. This time there were no low-memory messages from my printer 😀

The diagnostic still shows 127.83 / 256 MB available...?

Thanks for fixing the problem for me,

Paul

[Andr-1611]

Hi Paul,

this is a good information.

---

@Pecish wrote:

...

The diagnostic still shows 127.83 / 256 MB available...?

...

---

These are the optimum values and are OK. Look at my values:

Regards
Andreas