Unable to connect MFP M126nw to new wireless router

[avilondhe]

Hi,

Earlier my printer was connected to old router, but later when router was changed the connection was lost.

No as per help I am trying to connect printer to new wireless router bu I can't find wireless Wizard in menu.

Any instructions, steps from your side would be helpful.

Regards

[sabretooth04]

Replacing/changing your wireless router, try here.  

http://www8.hp.com/us/en/campaigns/wireless-printing-center/reconfiguring-system-help3.html

* Reset your printer back to Network Defaults.  Then run the Wireless Setup Wizard to connect.  Both can be accessed from the front panel or computer.  If no front panel for configuration, you must use your Printer USB cable to connect.  You can also try the WPS method if your router/printer supports this only if the Wizard or Printer USB cable is not available.
* Set router to a fixed wireless channel like 1, 6 or 11, never ‘auto’.  Try channel 1 first then the others one at a time.  
* Make sure printer and router are at least 5 feet apart.  
* The router must have the 2.4G SSID band enabled with a different name than your 5.0G SSID band in your router.  
* Make sure IPv6 is disabled in the printer.

Make and model of modem and router?

However if you have a Gateway (modem+router) device, all Gateway devices are terrible for wireless connectivity.   If this does not work, suggest you think about putting that gateway device in full bridge mode and install your own high quality router that YOU have full control over.