p1102w stuck on "IP Configured By = manual", how to fix?

[FiSach]

I had to IP adress 0.0.0.0 config manual.

I used util NtScrubber (https://uloz.to/!DyUETLYwkQks/ntscrubber-rar) or you can used new compurer was not connect to printer P1102w.

After clear all driver files by NtScrubber i can start install wireleas printer corect.

Now i have correct IP.

By FiSach

[JESTSTAR]

After doing a factory reset on my HP DeskJet P1102w I was able to find a way to assign a new static IP address to it.

I too had an IP address of 0.0.0.0 after doing a factory reset and was not able to route to it. I noticed that after a reset the printer has in Ad Hoc mode and transmitting a SSID of HP8AF51F.

I downloaded the newest driver installation package from HP onto a laptop, plugged the printer into a USB port on the laptop,  and ran the install.

I then connected the laptop to the printer's wireless SSID it was broadcasting (I didn't enter a passphrase).

I went through the setup wizard with the following choices "wireless install", "advanced install", "Connect to a configured Wireless Network Printer", "Specify a printer by address", "entered the printers mac address" (don't enter any dashed or colons in the mac address)

The wizard found the printer and then let me configure the TCP/IP settings and set a new IP address, Subnet Mask, and Gateway.

I found it strange that the laptop connected to the printer's wifi in ad-hoc mode, but it WORKED! I hope others find this helpful. 

If I was unclear please let me know and I'll do my best to explain my steps.