wifi re-connect problem

[blinkineck]

the wifi light is blinking and will not connect to my network

[asmita6658]

Hi @blinkineck

Welcome to the HP Support Community. I'd be happy to assist you with the connectivity issue. 

To better assist you - Is your router dual-band enabled i.e., both 2.4GHz and 5GHz? If yes, make sure the dual band has different SSIDs for 2.4G and 5G networks.

While you respond to that, let's try these steps -

Network Restore - Press the Wireless button and the Cancel button from the printer control panel at the same time, and then hold them for three seconds.

If the router has a WPS push button, try these steps -

1) Press and hold the Wireless button on the printer for more than three seconds to start WPS push mode. The Wireless light starts blinking.

2) Press the WPS button on your router.

NOTE: THE MOMENT YOU PRESS THE WIRELESS BUTTON ON YOUR PRINTER, WITHIN 30 SECONDS YOU SHOULD PRESS THE WPS BUTTON ON THE ROUTER.

You may also, try these steps -

1) Connect the printer using the Wireless Direct. Please refer to page#65 from the User Guide for steps. 

2) Open the browser and in the address or the URL bar type this - 192.168.223.1 to launch the EWS or the printer's page.

3) Go to the network tab > Wireless (802.11) and click on the Wireless Setup Wizard.

Once the printer is connected, the Wi-Fi LED on the printer will become solid.

You may also refer to this document - HP Printers - Install and Use the HP Smart App (Mac) 

Hope this helps! Keep me posted. 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping!

Have a great day!