F03 boot device not found error

[NewUser2023]

When turning on the Laptop -  hardware diagnostics come on all the time. , if I run hard drive check it says no detected, there is  scan disk M2 128gb chip installed

HP PC Hardware Diagnostic UEFI

If I press exit or continue it just loads up again to Same screen, it’s like it set to load from the hhd rather than the NVMe chip, but I can’t see a way in bois to show this ?

Hello, update to this : the laptop has a scan disk m.2 chip ssd that I don’t think is seen in bois , is there anything I can do to boot from the drive, it’s not listed in bois , how do I get it to show in bois . The laptop has been working . 

 

 

thank you for your help  

[Nal_NR]

Hi @NewUser2023,

Welcome to the HP Support Community. 

I'd like to help!

To be able to answer you effectively, we need some information

May I have the exact product name and number? Refer to this document for steps to find the product details. Do not share any of your personal information such as serial, phone number, email ID, etc.