Create an account on the HP Community to personalize your profile and ask a question
12-27-2018 12:43 AM
Upon booting up, system immediately displays a warning message that states the system is not fully configured. I am asked to contact HP support. Then the message disappears, the system continues to boot normally, and seems to operate normally.
This problem has appeared at least twice in the forum for other HP systems, and was in each case reported solved by running sssm.bat (apparently found in the wndmit folder of NbDmiFit). Apparently I need to get HP to run this proposed solution.
Anyone able to help me out with this?
12-27-2018 01:04 AM
NbDmiFit is a utility only available to HP Tech Support or HP ASP. You will need to contact HP for help with this:
**Click Accept as Solution on a Reply that solves your issue**
***Click the "YES" button if you think this response was helpful.***
Didn't find what you were looking for? Ask the community