cancel
Showing results for 
Search instead for 
Did you mean: 
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents and videos on compatibility, FAQs, upgrade information and available fixes.Windows 11 Support Center.
  • post a message
Bharath-99
New member
2 1 0 0
Message 1 of 4
451
Flag Post

Ssd not showing in the bios order

HP Recommended
Hp pavilion 15-cc129tx
Microsoft Windows 10 (64-bit)

I just installed M.2 pcie gen 3*4 and cloned all the os data but ssd is not showing in the boot order

3 REPLIES 3
Paul_Tikkanen
Level 21
Level 21
141,455 65,019 22,076 33,997
Message 2 of 4
Flag Post
HP Recommended

Hi:

 

Temporarily disconnect the hard drive and make sure Windows boots from the SSD.

 

It should automatically do so without any settings to enable in the BIOS.

 

If it does, go back and connect the hard up again, and you will need to remove Windows from the hard drive, or it will always want to boot from the 2.5" drive first.

Was this reply helpful? Yes No
Bharath-99
Author
New member
2 1 0 0
Message 3 of 4
Flag Post
HP Recommended

I tried but it didn’t work

 

should I change my legacy support to enable?

Was this reply helpful? Yes No
Paul_Tikkanen
Level 21
Level 21
141,455 65,019 22,076 33,997
Message 4 of 4
Flag Post
HP Recommended

Hi:

 

You can try that, but the notebook should have automatically booted from the M.2 SSD with the hard drive disconnected.

 

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation