-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Notebooks
- Notebook Boot and Lockup
- Re: asking for bios password after updating bios

Create an account on the HP Community to personalize your profile and ask a question
12-27-2016 11:30 PM
hi
iam new to this so forgive me if i have posted in the wrong place
i own an hp 250 g4 recently i updated my bios and after successful update i tried to enter bios and its asking for admin password but i never has set any admin password
it says system disabled [ | 87228416]
i can normally boot into my os but cant enter the bios
plz help me
Solved! Go to Solution.
Accepted Solutions
12-27-2016 11:47 PM
When prompted for password try 38180438
**Click Accept as Solution on a Reply that solves your issue**
***Click the "YES" button if you think this response was helpful.***
12-28-2016 12:11 AM
thanku sister helped me
i have another question
my down arrow key is repeatedly pressed even after removing the key
so any way to disable that particular down arrow key from internal keybrd ? via software or bios
12-28-2016 11:00 AM
You're very welcome. As for the key-I am not sure about that. Could perhaps be stuck due to some foreign particle ? Have you tried blowing it out well with can of compressed air? With laptop powered off
**Click Accept as Solution on a Reply that solves your issue**
***Click the "YES" button if you think this response was helpful.***
02-26-2019 04:31 PM
there is a hardare fix for recovering the bios but you must be careful. remove bat. slide off cover in back after unlatching with battery unlatch. find the 3 little bios pins, covered over by a 1 inch narrow black tape (on mine) and remove 2, carefully when powered off. power up. give password as same as username. power down. remove power again. replace caps and fire up unit. that should do it.