Antenna connections on Anatel chip are broken.

[JohnMac97]

I upgraded the RAM in a ZBook X2 G4 Detachable and the snap connectors stayed in the end of the antenna wires when they were disconnected. Can these be reattached with a conductive epoxy adhesive or does the whole system board need to be replaced?

[Jupitero]

Hello.

This very likely calls for system board replacement. The MHF4 coax antenna connector has two conductors in very small space. While in theory you could solder them or use a conductive adhesive, you would need to keep both conductors separate so working with a magnifier and a really steady hand with minuscule tools.

Perhaps an electronics repair shop could do this with special equipment, and could be worth a shot since the system board is likely going to be very expensive to replace. The wireless performance may still not be quite the same after operation...