-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Notebooks
- Notebook Hardware and Upgrade Questions
- Envy 13t-ad100 rear cover removal

Create an account on the HP Community to personalize your profile and ask a question
11-11-2021 10:03 AM
Upgrading SSD.. how to remove rear cover ?
It has 4 star like screws, one in each corner.
Does anyone know the actual screw size to remove the 4 screws, they look like Torx/Star.. and are very tiny ?
A tool part number or suggestion of where to purchase the correct tool, would be helpful
The Service manual, c05638816, which is generic to the 13-adxxx laptops, (page 31) shows a different back cover with 2 phillips in the center near the than my actual laptop, and suggest.
Instructions say:
(2) Four Phillips PM2.0×6.1 screws
(3) Two Torx5 M2.0×3.2 screws
The 13t-ad100 back cover is different , but has 4 Star like screws, perhaps Torx, one in each corner, but I cannot seem to find a Torx5 M2.0 tool.
11-11-2021 02:42 PM
Please use the following manual
http://h10032.www1.hp.com/ctg/Manual/c05638816.pdf
Regards.
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.
11-21-2021 10:29 AM
OK Thanks.. that is the manual I have and use...
I think there is a bit of a mis-print. my laptop has only 4 screws one in each corner. plus two hiden under the rubber strip.
The (4) corner screws I have now the right tool.. it is in fact a Torx 5 screw.