Gpu Overheating

[realmofgeorge]

I have a sort of weird situation, I upgraded my 15-cb060sa with another 8gb stick of ram and a m.2 ssd, I did some dusting too but now my pc won't boot properly. It blue screens me and when I try to boot again it gives me 090d which I believe is overheating. When I do try to boot the fans spin up really fast until the pc shuts down due to the overheating. I can boot up to windows if I go to system diagnostics and start a memory test, then cancel, the fans stop spinning up so fast but when I log into windows my 1050 gpu isn't there. I tried a cmos clear but the problem persists. I had no overheating problems before hand, obviously the fans and heatsink are clean so maybe it could be a sensor problem? Any ideas are welcome and thank you for any replies.

[The_Fossette]

@realmofgeorge

I reviewed your post and I understand that the computer is not booting to Windows and the fan is spinning continuously.

Don’t worry, I assure you I will try my best to get this sorted.

Have you tried to boot with the original hard drive on the computer?

Meanwhile, I recommend you restore the BIOS defaults following the steps in the below article and check if it helps.

https://support.hp.com/in-en/document/c04831065

If you continue facing the issue, then update the BIOS and graphics driver from the below link and check if it helps.

BIOS: https://ftp.hp.com/pub/softpaq/sp106001-106500/sp106010.exe

Graphics: https://support.hp.com/in-en/drivers/selfservice/hp-pavilion-power-15-cb000-laptop-pc/15551388/model...

Let me know how it goes and you have a great day!

P.S: Welcome to the HP Support Community 😊

If you wish to show appreciation for my efforts, mark my post as Accept as Solution. Your feedback counts!

Cheers!

Stay Home – Stay Safe