HP Photosmart C5180 All-in-Oneos

[Gma3hegney]

Printer will not print says error Oxc18a0206. What does this mean?

[KrazyToad]

@Gma3hegney

Let's start with a Printer Reset

- Turn on the printer.
- Wait until the printer is idle and silent before you continue.
- Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.
- Remove the ink cartridges from the printer.
- With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.
- Wait at least 60 seconds.
- Plug the power cord back into the wall outlet.
NOTE: HP recommends connecting the printer power cord directly to a wall outlet.
- Reconnect the power cord to the rear of the printer.
- Turn on the printer, if it does not automatically turn on.
- The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
- Wait until the warm-up period finishes and your printer is idle and silent before you proceed.
- Reinsert the ink cartridges, and then close the ink cartridge access door.
- If you receive a prompt to print a calibration page, do so.

Next update the Firmware. You can refer to this Link: https://support.hp.com/in-en/document/c02919168 for help with the Firmware update

You can also refer to this Link: https://support.hp.com/us-en/product/hp-photosmart-c5100-all-in-one-printer-series/1153538/model/115...

Keep me posted 😊

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.