• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Here is the solution to resolve for 5 Long and 3 Short Blinks on your HP Laptop Click here to view the instructions!
Common problems for Battery
We would like to share some of the most frequently asked questions about: Battery Reports, Hold a charge, Test and Calibrating Battery . Check out this link: Is your notebook plugged in and not charging?
HP Recommended
13-ac001na (Spectre x360 2017)

Hi all.

 

I need to replace the SSD on my Spectre X360 (https://support.hp.com/gb-en/product/HP-Spectre-13-ac000-x360-Convertible-PC/14039877/model/15232097).

 

I tried to open up the back panel by removing all the hex screws, but it doesn't budge. Feels like it's glued down or something. I tried to remove the rubber "feet" to see if there are any screws behind, but the ones at the back seem to have some plastic gear like things behind them and the feet seem mechanically attached rather than glued on. The feet on the front seem glued on pretty tight, but I didn't want to pry to hard.

 

Are there any instructions on how to remove the panel or otherwise access the SSD if the back panel isn't the right approach?

 

Thanks.

 

 

 

1 ACCEPTED SOLUTION

Accepted Solutions
HP Recommended

Hi

 HP Spectre x360 Convertible PC Model numbers: 13-w000 - 13-w099 Model numbers: 13-ac000 - 13-ac099 ...3.34MB

 

Page 24 onwards...

Remove the bottom cover:1.Position the computer upside down with the front toward you.2.Remove the two rubber feet from the top of the bottom cover (1).24Chapter 5 Removal and replacement procedures for Authorized Service Provider parts

 
 

3.Remove the two Phillips PM2.0×5.0 screws (2) and the six Torx T8M2.0×3.0 screws (3) that secure the bottom cover to the computer.4.Insert a tool into the bottom right corner and pry the cover loose (1).5.Remove the bottom cover (2).Reverse this procedure to install the bottom cover

 

Don't forget the pry bar.

 

 

View solution in original post

5 REPLIES 5
HP Recommended

Hi

 HP Spectre x360 Convertible PC Model numbers: 13-w000 - 13-w099 Model numbers: 13-ac000 - 13-ac099 ...3.34MB

 

Page 24 onwards...

Remove the bottom cover:1.Position the computer upside down with the front toward you.2.Remove the two rubber feet from the top of the bottom cover (1).24Chapter 5 Removal and replacement procedures for Authorized Service Provider parts

 
 

3.Remove the two Phillips PM2.0×5.0 screws (2) and the six Torx T8M2.0×3.0 screws (3) that secure the bottom cover to the computer.4.Insert a tool into the bottom right corner and pry the cover loose (1).5.Remove the bottom cover (2).Reverse this procedure to install the bottom cover

 

Don't forget the pry bar.

 

 

HP Recommended

Hi,

On page 24 of service manual you can see how to remove the bottom cover. There are screws under the back rubber feet. You will need to puncture or remove the plastic under the rubber feet to get to the screw:

http://h10032.www1.hp.com/ctg/Manual/c05357578

 

Hope it helps,

David

 

Please click on thumbs up for thanks

Please click on accept as solution if answered your question

HP Recommended

Thanks guys. I'll give it a go.

HP Recommended

Thanks guys. I had to put the pick UNDER the gear like plastic part attached to the rubber feet. That did the trick.

HP Recommended

Prego.

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.