• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Are you having HotKey issues? Click here for tips and tricks.
Common problems for Battery
We would like to share some of the most frequently asked questions about: Battery Reports, Hold a charge, Test and Calibrating Battery . Check out this link: Is your notebook plugged in and not charging?
Locked

‎07-08-2022 07:50 AM

HP Recommended
Product: HP Pavilion Gaming - 15-ec0007nf

 

If it is than I saw a motherboard with RYZEN 5 4600H + 1650 4GB but it has the 150w DC connector instead of the 200w that my fried laptop had. If I replace the power connector cable (to the 150w model) will my last charger the 200w charger be good or will I have to replace my charger too?

Category:
3 REPLIES 3

‎07-08-2022 01:42 PM

HP Recommended

@Kukac285 

 

You can use higher wattage rating charger (or AC Adapter) for machines on a same series. Is your new system board on the same series of your machine ? What is its part # ?

 

Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.




Was this reply helpful? Yes No

‎07-08-2022 02:03 PM

HP Recommended

My fried motherboard was the L71932-601 (With Ryzen7 3th gen + 1660) and what I want is L91092-601 (With Ryzen5 4th gen + 1650). To me the two motherboard looks identical, only the DC port looks different.

Was this reply helpful? Yes No

‎07-08-2022 04:42 PM

HP Recommended
@Kukac285 wrote:

.. what I want is L91092-601 (With Ryzen5 4th gen + 1650). To me the two motherboard looks identical, only the DC port looks different.

@Kukac285 

 

Your machine is NOT on the following list

 

              https://partsurfer.hp.com/partsurfer?searchtext=%20L91092-601

 

But I believe holes for screws and ports locations should be on the right places.

 

Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.




Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.