Removing Intel optane memory ans installing ssd

[Jfzl]

My notebook have an Intel Optane memory M10 (16GB) preinstalled. 

So i was trying to remove this and install an SSD on the same port. I brought a HP SSD EX900 M.2 250 GB and installed on same port. 
Unfortunately my system doesn’t detected it.

i tried enabling legacy mode, then removed Optane memory and reinstalled os on HDD, but nothing worked.

is there any solution for this ?

[banhien]

@Jfzl 

You have to use following steps

Did you disable Optane before removing it ? You also have to remove HDD to allow system to boot on new SSD then put old HDD back later.

Regards.

[Jfzl · Accepted solution]

I didn’t disabled the Optane memory. 
But, i did the below steps and everything worked fine

• Removed Optane memory 
• enabled legacy support
• When i rebooted, it asked me to reset RAID, and i did the same
• Reinstalled windos 10 on HDD
• Disabled legacy support
• Now, when i checked in dispart and disk management, ssd is detected. But before installing os in ssd, we need to convert from MBR to GPT
•