• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Are you having HotKey issues? Click here for tips and tricks.
Common problems for Battery
We would like to share some of the most frequently asked questions about: Battery Reports, Hold a charge, Test and Calibrating Battery . Check out this link: Is your notebook plugged in and not charging?
HP Recommended
15 da0012dx laptop
Microsoft Windows 10 (64-bit)

Hi all,

 

so in my refurbbed HP  15 da0012dx   laptop the DVD drive died and I bought a replacement.

 

Do I just power down and swap it out, or do I need to take it apart and remove the battery first ? 

 

also, any hints on getting the old bezel cover off the old and onto the new drive? 

 

all advice appreciated, my first one of these.  THANK YOU 

 

Justin  

1 ACCEPTED SOLUTION

Accepted Solutions
HP Recommended

Hi, Justin:

 

Here is the link to the HP video for removing and replacing the DVD drive...

 

Replace the Optical Drive | HP Notebook 15, HP 250 and 255 G7 Notebook PC | HP - YouTube

 

There is no need to remove the battery.

 

However, I would not have the PC connected to the power adapter.

 

Unfortunately, since I do not know how the bezel is secured I wouldn't be able to help you with that.

 

You'll have to look carefully at how the bezel is attached to the existing drive.

 

Normally, it is held on by a couple of very delicate plastic tabs/clips that you bend to release the bezel.

View solution in original post

5 REPLIES 5
HP Recommended

Hi, Justin:

 

Here is the link to the HP video for removing and replacing the DVD drive...

 

Replace the Optical Drive | HP Notebook 15, HP 250 and 255 G7 Notebook PC | HP - YouTube

 

There is no need to remove the battery.

 

However, I would not have the PC connected to the power adapter.

 

Unfortunately, since I do not know how the bezel is secured I wouldn't be able to help you with that.

 

You'll have to look carefully at how the bezel is attached to the existing drive.

 

Normally, it is held on by a couple of very delicate plastic tabs/clips that you bend to release the bezel.

HP Recommended

Thank you thank you  

 

I am sure i can handle the bezel with a paperclip as needed 🙂  

 

much appreciated esp when microcenter told me to take the battery out, yeesh  -- jl  

HP Recommended

You're very welcome.

 

Normally it is good practice to remove the battery in most cases when working inside a notebook, but it is normally not necessary when replacing a DVD drive, because you are not working 'inside' your notebook to remove the DVD drive in your notebook's model series.

HP Recommended

aha  well thanks for that insight.   hopefully I won;t have to dig into the guts any tie soon. 

 

thanks to you I was successful I am so happy 🙂 

 

The bezel, I need to do another post for that,   I can see the 2 clips and so far no luck pulling them out.  worst case I can chop up the old dead drive with a dremel tool.  hopefully there is a trick to be learned.    jl  

HP Recommended

Anytime.

 

Glad to have been of assistance.

 

Sorry that removing the bezel from the old DVD drive is difficult.

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.