Spectre x360 2020 Thermal Profiles won't work in tablet mode

[3__3]

After a lot of trial and error I've found out that my laptop is overheating because it's always in tablet mode and the fans will not spin up until I flip the keyboard around. I'm using the HP command center to adjust the cooling. Is this a known issue?

[praveen196]

@3__3 Welcome to HP Community!

I understand that you are facing overheating issue.

I have a few steps to resolve this issue:  

Symptoms of heat issues and causes of excessive heat  

The following list describes some of the issues caused by overheating in the notebook:  

• Games stop responding during play.  

• Windows stops responding during use.  

• Fans inside the notebook become louder because they are spinning faster as the laptop gets hot, to remove the heat.  

• When starting the laptop, it sometimes stops at a black screen and does not open into Windows. Windows usually stop responding when it does open.  

The following list describes some causes of excessive heat:  

• Dust inside the laptop.  

• A new component, such as a hard drive, is added. The extra component causes the power supply to work harder and generate more heat. Extra heat also radiates off the new component and adds to the temperature inside the case.  

• Over time, some cooling fans might slow down and wear out, as the laptop is getting hot, depending on the usage of the laptop.  

• High ambient room temperature.  

Step 1: Removing dust and lint by cleaning vents  

Step 2: Ensuring proper space for ventilation  

Step 3: Updating the BIOS  

Step 4: Using HP CoolSense technology  

Step 5: Placing the notebook in a cooler room  

Step 6: Testing for hardware failure  

If the hardware has failed, capture the failure ID and revert for further assistance.  

 
If the Fan is Noisy and Spins Constantly, PC is Warmer than Normal: Click here for more details. 

Keep us posted,

If you would like to thank us for our efforts to help you, 

Give us a virtual high-five by clicking the 'Thumbs Up' icon below, followed by clicking on the "Accept as solution" on this post, 

Have a great day!

[3__3]

Praveen, as I've stated in my post, it's only on tablet mode the fans will not spin up. It's a brand new computer, so there's not a dust issue. There seems to be a software issue where tablet mode disables anything set in hp command. I just needed to confirm that all units have this issue 

[praveen196]

@3__3 

I understand your concerns. 

In that case, I would suggest you perform the system reset.

Windows 10 has a reset feature that repairs your computer by reinstalling the operating system. This feature is recommended for recovery because it reinstalls Windows 10 while either preserving your personal data and customizations or removing all your personal data.

You have a choice of two methods to reset your computer.

• If Windows 10 loads correctly, see the section titled Perform a Windows 10 system reset in Windows in this document.

• If Windows 10 does not start correctly, see the section titled Perform a Windows 10 system reset through Windows Recovery Environment in this document.

Have a nice day!!