• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Are you having HotKey issues? Click here for tips and tricks.
Common problems for Battery
We would like to share some of the most frequently asked questions about: Battery Reports, Hold a charge, Test and Calibrating Battery . Check out this link: Is your notebook plugged in and not charging?
Locked

‎12-04-2019 06:05 AM

HP Recommended
Product: ENVY 17-j101ex Leap Motion TS SE Notebook PC
Operating System: Microsoft Windows 10 (64-bit)

Hi,

i format my C drive yasterday and try to install new windows 10 from usb flash drive but when i choose the C drive to install windows on it i got this message "windows cannot be installed to this disk the selected disk has an mbr on efi systems"

i make some research and i found i should use this command: 1)DISKPART - 2)LIST DISK - 3)SELECT DISK Number - 4)CLEAN

but when i type DISKPART i only get 2 partition and i have 3 not 2 like this :78767951_457003005240000_745288623854714880_n.jpg

 

i want to install my windows on Drive 0 Partition 2 so which Disk should i select ?

1 ACCEPTED SOLUTION

Accepted Solutions

‎12-04-2019 07:08 AM

HP Recommended

Hi:

 

If I were you, I would go into the BIOS, enable legacy mode and disable secure boot.

 

See this link for the settings to change.

 

https://www.support.hp.com/us-en/document/c03736054/

 

Then boot from the Legacy USB flash drive instead of the EFI one, and you will be able to install W10 on the MBR partition you want.

View solution in original post

Was this reply helpful? Yes No
1 REPLY 1

‎12-04-2019 07:08 AM

HP Recommended

Hi:

 

If I were you, I would go into the BIOS, enable legacy mode and disable secure boot.

 

See this link for the settings to change.

 

https://www.support.hp.com/us-en/document/c03736054/

 

Then boot from the Legacy USB flash drive instead of the EFI one, and you will be able to install W10 on the MBR partition you want.

Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.