12-04-2011 10:13 PM
I had a Windows 32 System Error. A file was corrupt or missing.
I first had to go into the Bios and disable SATA Native Mode.
Then, I put in the Windows Recovery Disk I purchased from Amazon.
I went to a screen that read, "Microsoft Windows XP(TM) Recovery Console
The Recovery Console provides system repair and recovery.
Type EXIT to quit the Recovery Console and restart the computer.
Which Windows installation would you like to log onto
(To cancel, press ENTER)
This didn't work at all.
So I went back to try a step (Recovery Mode F11) that initially didn't work but
I noticed more progress since I disabled the SATA Native mode.
So I went to Recovery Mode and this time it worked.
I recovered Windows back to Factory settings.
Do I have to go back and enable SATA Native now?
12-05-2011 06:47 AM
It is best if you can, but you cannot until you install the SATA ACHI driver.
If you have an Intel processor, I can help you do that. If you have an AMD processor, I can't because I don't know how.
If you have a notebook with an Intel processor, please post your full notebook model.
It isn't really a big deal if you can't change the setting back. You'll hardly notice any difference.
It is just that ACHI mode allows the hard drive to perform more efficiently for lack of a better word.
See this article for more info.
04-27-2017 02:34 PM
Note book model : hp 14 notebook PC
BIOS version : F.24
processor type : intel(r) celeron
I really need help to fixe this
- HP PCs - How to Change or Reset Password (Windows 10)
- Downloading or Updating Software and Drivers for HP Computers
- HP PCs - Sleep and Hibernate Issues (Windows 10, 8)
- HP PCs - How to Reset Your Computer to Factory Settings (Windows 10, 8, 7)
- HP PCs - Updating Drivers and Software with Windows Update (Windows 10, 8)