Battery calibration

[Laptopissues101]

When I'm calibrating my lap top it gets up to 50% and 2 hours and 2 minutes then completely stops is this normal for it to do? Do I keep it plugged in because it also says attempting to turn off AC charger 

[ub6424]

Sorry to hear that you are having problems ... 

Do the following trick ...

(1) Open the windows device manager and uninstall the "Microsoft ACPI-Compliant Control Method Battery" 

- Right click on "Microsoft ACPI-Compliant Control Method Battery"

- Click "Uninstall device"

- Confirm your choice if you see a popup notification

(2) Shutdown your notebook/computer

(3) Remove battery, remove ac adapter, press and hold the power button for 30 seconds.

(Note: If do not have the technical skills to remove the battery (most notebook has to be diassembled !) , just start the notebook and go directly into the bios (ESC/F1/F2/F10) and let the notebook stay there or run HP Diagnostic Test loops to drain the battery (don't connect the AC adapter !) until it is switching off automatically

(4) Install battery, plugin ac adapter and wait until the battery is fully charged (don't start the windows operating system !) and check the charging led.

(5) If you do have no charging led, wait at least 2 hours ...

(6) Start your notebook/computer, now the windows battery management system is synchronized with your installed battery. Normally it should show 98-100% battery level.

(7) If your battery level is too low and you are loosing your battery capacity too fast, your battery has to be replaced...