Driver for PCI Simple communication Controller (Win-10 fresh install)

[EffeLenz]

Hi, I just installed  a version of Windows 10 Pro x64
(21H2) on a new SSD, my computer is an HP 250 G1 notebook .
Unfortunately I can't configure some driver
in particular the driver of PCI Simple communication Controller is not installed.
This is the Hardware ID :
PCI\VEN_8086&DEV_1E3A&SUBSYS_1854103C&REV_04\3&11583659&0&B0
Please can you point me out
where to find this driver?

[Paul_Tikkanen · Accepted solution]

Hi:

You need this driver for that device...

This package provides the Intel Management Engine Components Driver for supported notebook models running a supported operating system.

https://ftp.hp.com/pub/softpaq/sp65501-66000/sp65514.exe 

[EffeLenz]

Thank you so much Paul your help was effective,
but now in device manager there is still a PCI device with the warning

The device PCI\VEN_10EC&DEV_5229&SUBSYS_1854103C&REV_01\4&18138212&0&00E2
requires further installation.

I thought I could solve with your suggestion but probably I need an additional driver.
confirm my thoughts ?

[Paul_Tikkanen]

You're very welcome.

Yes, you are correct.  You need the Realtek SD card reader driver for that device...

This one should work for your notebook...Directly from the Realtek site, as the card reader drivers for the 250 G1, G2 and G3 are too old (for Windows 8.1 only), and the SD card reader may not work with those.

Download, unzip and run the setup application from the 1st file listed at the link below...

Card Reader Solutions > Card Reader Controllers Software - REALTEK

[EffeLenz]

hank you Paul,

You have been very helpful once again
my computer now updated in all its drivers and even if it is a bit dated it responds really well

[Paul_Tikkanen]

Anytime.

Glad to have been of assistance.